![]() ![]() The cables can then be fed behind the radio into the cavity of the lower center panel and out to the armrest. Once the center panel has been removed, use the Phillips screwdriver to remove the two screws under the ashtray so that the lower center panel can be removed (the panel containing the ash tray, cigarette lighter and seat controls). For manual transmission vehicles, twist the knob anti clockwise to remove it. Step 8: If you choose to store in the center armrest, open the center armrest and pull the trim upwards where the latch closes. Mount the mic and run cable to module too. They can be fed through to the glove box or underneath into the centre arm rest. Step 7: Once you are happy with the functionality, find a place to store any audio cables eg. If there’s a CD in you may have to push it again Step 6: Pair phone if it’s a bluetooth kit and test the functionality to see if it’s all working. Turn the key off for a good 20 seconds before trying again Often it’s not recognised the 1st time you switch it on. Connect the Mazda cable harness into the CD changer port. ![]() Step 4: Identify and unplug the connection in the external CD Changer port (same as the plug on supplied cable) on the back left of the head unit, looking down from the top (1:44 in to vid below). Step 3: Lift the front edge of the top panel with the air-conditioning vents to pull the radio out. Use the trim tool or flat screwdriver to unhook the four clips holding the silver trim in place. Mazda 3 Radio Removal Step by Step Instruction Guide ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |